Build the BEST DIY 3D Printer – Arduino Coding and firmware upload 2/2 #17

Hello guys and welcome back to another video of Architects3DP! This is the seventeenth episode of the “Build the BEST DIY 3D Printer” series, [Animación lista fondo difuminado] In the last episode, we started programming the firmware for our custom 3D printer, that if you remember, is the Marlin 1.1.9.! In this video we are […]

RAMPS 1.4 – Stepper marlin firmware extruder calibration

Okay, we want to calibrate the Stepper configuration that we have here, and I’m going to show you real easy method to do this What you want to do is you want to line up your filament inside your tube? So that it’s at just the tip of where you are and what you’re gonna. […]

RAMPS 1.4 – Marlin 1.1.8 Firmware Basics

today I’m going to talk to you about the Marlin firmware for configuration.h I’ve been getting a lot of questions lately on how to configure some stuff that myself and others that are new to this have come across so I’m going to go over a little bit this is the Marlin, “configuration.h”, tab normally […]

Copyright © 2019 Geted Tabs Online. All rights reserved.